Excellence Dental Studio

+355692084004 / +355692097900 info@studiodentare.com

Computerized Prosthetic

Ultimate CAD CAM technology

cad camThis technology , which until a few years for many dentists was a dream , today helps us in the daily work with patients .

Everything starts with the desire to improve known and unknown medical procedures . The traditional way of building the tooth is known by most , if not by all dentists in Albania and in the world . But the desire for strong and beautiful fillings builded the CAD CAM computer system

In our studio we work with sirona Mx CL in Lab CAD CAM

Thanks to advanced computer technology , we are able to rebuild in short time porcelain crowns , full porcelain, glass high porcelain, porcelain Veneers inlay and many other ceramic fillings within 1 hour , that is the duration of a normal visit .

Same as in the traditional method , even here tooth must be cleaned by Caries and old fillings . In addition , after a preliminary conversation with the patient is made the decision on filling materials that will be used : traditional , which is sufficient for filling small spaces , or computerised , who is used for loss of medium and large size of the tooth .

Virtual model and design of the crown.

Lacks of the tooth part, which include areas where teeth make contact , or occurr below the gum , or / and are large , can be treated by cosmetic lay systems of models inlay / onlay / Overlay .

These terms indicate a filling , which is performed outside the patient’s mouth , in our case via PC .
Construction of the tooth can be made with different materials : composite , ceramic , or metal ( eg . Gold ) .
We propose mostly ceramic fillings system . After cleaning the teeth , as well as the empty spaces of the tooth surface within the mouth is scanned by a scanner in the form of pen . The whole rest of the procedure is done on the computer .
Virtual model of the tooth is observed and studied with care and subsequently used for preparing the filling .

agent1

Once approved by the doctor all the parameters , a special milling within a time frame of 10-15 minutes cuts the filling out from a ceramic block , and then it is adjusted depending on patient bite and giving the form of glare .

The entire process takes 1-2 hours . This is a remarkable achievement , because all this work done by traditional methods would last 3-5 days .

Virtual model and design of the crown .
Is necessary to use inlay ? The answer is yes. Are a more durable and a more aesthetic reconstruction of structures lost in the crown

Over the years, traditional fillings lose their hermeticity and so microflowing occurr , which bring as a result the need of changing the filling .

Something like this happens very rarely , when inlay is used. Considering all the pluses and minuses with full conviction we recommend our patients this form of dental filling , without worrying about the need for any other intervention in the tooth for a really long while.

Now , thanks to the introduction and use of the new system – Cerec 4.0 – it is possible to perform more complex interventions prosthetic even during a single visit